When both LK5 and LK7 are open the board is configured for full duplex operation. When both LK5 and LK7 are closed the board is configured for half duplex operation. When LK5 is closed the receiver input B pin is connected to the driver output Z pin. This is a GPIO male connection to be used with the Arduino version of the board EVAL ADM2587EARDZ Ground terminals are provided for cables with ground wires. A and B are the ADM2587E receiver inputs while Y and Z are are the driver outputs. This 6-way connector is used for an RS-485 bus cable. This is used to supply power to the logic side of the board. This is used to connect the ADM3260 isolated I2C or ADuM3151 isolted SPI to external devices. This is a GPIO female connection to be used with the raspberry pi version of the board EVAL ADM2587ERPIZ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |